START ENGINE STOP Button overlay 3D Domed Gel Resin Stickers Decals SINGLE (Custom Made)
The size of our Round 3D Domed Gel stickers decals are in mm = wide/dia
Sizes Available: 10mm, 11mm, 12mm, 13mm, 14mm, 15mm, 16mm, 16mm, 17mm, 18mm, 19mm, 20mm, 21mm, 22mm, 23mm, 24mm and 25mm.
If you require a different size then please use the Ask a Question below.
This is for a SINGLE Round luxurious aftermarket custom made 3D Domed Gel ENGINE START STOP Button badge sticker.
Made from external grade self adhesive eco-solvent printed vinyl and topped with a luxurious 3D Domed Gel that gives a stunning protective layer and a glossy look.
Domed stickers decals/badges are covered with up to 4mm thick, transparent, polyurethane coating for a 3D look. They are semi-flexible, scratch resistant , flat on the back and must be fitted to a clean, smooth surface but can be applied to slightly curved surfaces, if curve is greater than 1mm-2mm depth from the center to the outer edge depending on the overall diameter then additional adhesive may be required.
Some colours may appear slightly lighter when combined with our 3D Domed Gel. This is due to the light reflecting within the 3D Domed Gel coating.
Please note: The designs produced by this Wheel Badges builder are a computer generated visual representation of the final badge and only for guidance. All our 3D domed gel custom badges are handmade, therefore, there may be imperfections and differences on positioning for each and every badge.
These aftermarket 3D Domed Gels are custom made to order and are not a stock item, therefore not covered by the distance selling act.
If you are unsure what Custom Made means then please ask before placing your order.
All our 3D Domed Gel products can take up to 5 working days to fully cure. We do have an advanced curing system that can cure these in as little as 24-48 hours but this is dependant on available space. We do not colour match.